Page 1 of 1

Rostock MAX v3.2 Settings

Posted: Sun Sep 16, 2018 8:44 pm
by jcarlin
Been working on this Rostock Max v3.2 FFF for Simplify3D and I am pretty sure its just about there. I took a mix of the standard Simplify3D profile for the RMAXv3, the proposed settings for Cura from SeeMeCNC and the settings for the Artemis. It prints very nicely on my freshly upgraded v3.2. You might need to tweak the temps for your own liking.

I also included a bonus! Messing around I figured out how to add the Rostock base under the build plane. The .stl and where to put it are included in the zip file. Move the file into place before you import the FFF.

Example image: https://drive.google.com/file/d/1gwIcXZVLACP-AzHsV-jv72wl5h-D5CjV/view?usp=sharing

Files:
RMAXV32_SIMPLIFY3D.zip
(800.08 KiB) Downloaded 31 times


Enjoy!

Re: Rostock MAX v3.2 Settings

Posted: Thu Sep 20, 2018 7:56 pm
by jcarlin
I have a new version of my S3D FFF for the v3.2...

Spent most of the day tweaking the settings until I virtually eliminated my stringing. Still dialing everything in, but thought I would share my work in process.

Re: Rostock MAX v3.2 Settings

Posted: Fri Sep 21, 2018 9:16 am
by geneb
Keep in mind that stringing is going to vary from roll to roll.

g.

Re: Rostock MAX v3.2 Settings

Posted: Tue Sep 25, 2018 10:30 am
by jcarlin
Hopefully the profile will give others a starting point. Though I was getting consistent stringing across all of my PLA and PETG rolls. My latest settings seems to have eliminated 99% of it. YMMV