HE280 Upgrade and Extruder Stepper Stops Working

Discussions related to the Rostock MAX v2
MichaelF
Noob
Posts: 3
Joined: Mon Dec 07, 2015 1:10 pm

HE280 Upgrade and Extruder Stepper Stops Working

Postby MichaelF » Sat Dec 09, 2017 4:21 pm

I upgraded to the HE280 hotend and all the wiring seemed to go well. I also upgraded the firmware per the instructions.

The calibration appeared to go well so I started a calibration print in MatterControl. Two issues happened at this point. The print head was about 5mm from the glass while printing and the extruder didn't work.

Any ideas on where I can look to track down the issue?

Thanks,

Mike

Return to “Rostock MAX v2”

Who is online

Users browsing this forum: No registered users and 1 guest