Advanced Calibration

Discussions related to the Rostock MAX v2
knightwolf313
Plasticator
Posts: 5
Joined: Fri Sep 11, 2015 2:40 pm
Location: Oregon

Advanced Calibration

Postby knightwolf313 » Fri Oct 27, 2017 6:54 pm

So I followed the standard calibration for my Max2 by using the paper test at each tower and center. however when I do a test print.(https://www.thingiverse.com/thing:25763) I find that the X-axis and Y-axis (cross and back) are .5mm long and the Z-axis(up) is .5mm short.
It seams I remember hearing something about an advanced calibration instructions, but I cant seem to find them. does anyone have a link to the advanced calibration? .5mm might not seam like much, but its enough to really foul up a complicated multi part model.

User avatar
pouncingiguana
Printmaster!
Posts: 150
Joined: Tue Nov 15, 2016 8:48 am

Re: Advanced Calibration

Postby pouncingiguana » Mon Oct 30, 2017 7:47 am

Good news/bad news.

Good news: The advanced calibration is posted on the website (https://www.seemecnc.com/pages/delta-calibration-wizard) and it will work on a V2.

Bad news: It's gonna take a while to do this manually since you don't have a probe. You'll have to do the paper test at all 10 points and enter the offset.

I've done it on 1 V2 and that was enough for me :p

Good luck!


Return to “Rostock MAX v2”

Who is online

Users browsing this forum: No registered users and 1 guest