Print Quality and Time

Discussions related to the Rostock MAX v2
Post Reply
soul_reaper_38
Prints-a-lot
Posts: 31
Joined: Sun May 10, 2015 6:45 am

Print Quality and Time

Post by soul_reaper_38 » Mon Apr 10, 2017 12:53 am

After a few months of inactivity I fired up my Rostock Max V2. I never really fine tuned it so I was hoping to get some feedback.
What kind of bothers me more than anything is the print time. Should this take 2 hours to print? I'm using MatterControl to slice.
I set it to .3mm thickness and 10% infill. Speeds are 60mm/s perimeter, 80mm/s infill. 2 count shell with 6 top layers and 4 bottom layers. Printed with supports and a raft. 210C extruder and 60C bed.
I see warping towards the aft of the boat and there were a lot of strings to clean up so I'm messing with the retraction.
Please, any help is appreciated.
http://imgur.com/a/2dPYC

nebbian
Printmaster!
Posts: 175
Joined: Wed Sep 23, 2015 12:31 am

Re: Print Quality and Time

Post by nebbian » Mon Apr 10, 2017 3:33 am

What is your acceleration set to (in firmware and in the slicer)?

User avatar
Renha
Printmaster!
Posts: 282
Joined: Fri Apr 11, 2014 2:18 am
Location: Balashikha, Russian Federation
Contact:

Re: Print Quality and Time

Post by Renha » Tue Apr 11, 2017 4:44 am

any "Layer min cool time" setting in your slicer?
3D printing is magic!

Sorry my engrish :-/ you could PM me in Russian.

Post Reply

Return to “Rostock MAX v2”