---Just to become more knowledgeable I am crawling through the duet parameter files as a precursor to looking at https://configurator.reprapfirmware.org/
I just confirmed that my slicer (simplify3d) is putting M83 into the print job preamble to enable relative extrusion.
I don't think I need to do anything else? Correct?
One thing I did notice that the slicer did not have as illustrated in the sublimelayers blog post below;
"Allow zeroing of extrusion distances" checked;
I don't think allow zeroing of extrusion distances is needed with M83 on. Is that observation correct?
M104 S200 T0
M109 S200 T0
G28 ; home all
G1 E-3.2000 F500
G1 Z1.115 F1200
; process Process1
; layer 1, Z = 0.315
; tool H0.350 W0.550
G1 X62.825 Y-74.675 F9000
G1 Z0.315 F1200
G1 E3.2000 F150
G1 X62.825 Y88.493 E11.4916 F1900
Post your prints with the GCode used to help other users achieve a similar result, or get help.
2 posts • Page 1 of 1
Correct, zeroing of extrusion distance only applies when you use absolute extruder coordinates.
Who is online
Users browsing this forum: No registered users and 2 guests