Post your prints with the GCode used to help other users achieve a similar result, or get help.
2 posts • Page 1 of 1
I recently started this project to make my own custom pause G-code and I wanted to add a function to resume the print with the click of the encode on the LCD Panel. I looked on the Wiki page for possible commands that are compatible with the Repetier Firmware but I never found anything to use the encoder. Now I am wondering if it is possible to control the printer with the encoder to start the printer the way I want to. Suggestions or ideas would be greatly appreciated. Thanks for your time.
Who is online
Users browsing this forum: No registered users and 1 guest