G-code for LCD Encoder?

Post your prints with the GCode used to help other users achieve a similar result, or get help.
Post Reply
Posts: 35
Joined: Wed Nov 04, 2015 4:56 pm

G-code for LCD Encoder?

Post by jmargush » Fri Apr 01, 2016 1:35 am

I recently started this project to make my own custom pause G-code and I wanted to add a function to resume the print with the click of the encode on the LCD Panel. I looked on the Wiki page for possible commands that are compatible with the Repetier Firmware but I never found anything to use the encoder. Now I am wondering if it is possible to control the printer with the encoder to start the printer the way I want to. Suggestions or ideas would be greatly appreciated. Thanks for your time.

User avatar
Posts: 7185
Joined: Sun Apr 01, 2012 5:26 pm

Re: G-code for LCD Encoder?

Post by Eaglezsoar » Fri Apr 01, 2016 4:22 am

Hi jmargush!

See this link, it may be of some help to you.

“ Do Not Regret Growing Older. It is a Privilege Denied to Many. ”

Post Reply

Return to “GCode & Test Prints”