Issue with printer not printing on bed

A place to post your fails. We know you got 'em, now share what you think caused 'em
Bismarck83
Noob
Posts: 2
Joined: Mon Mar 23, 2015 12:35 pm

Issue with printer not printing on bed

Postby Bismarck83 » Wed Apr 26, 2017 6:20 pm

I have an Orion Delta. worked wonders till the old mobo fried. After getting a knew one (months later) I kinda forgot how to do a lot of stuff, I am hoping you guys can help me out. below is my eeprom settings if it helps. I zeroed in the tip to be flush with the bed manually, saved settings exported it to EEProm , everything looks good but when it begins to print it hovers a few ..maybe 1/4 of an inch (guessing) and starts to print off the board in the air., I checked the zeros again and everything seems fine.

I am using a Orion delta printer
Using Matter hackers slicer

hope you guys can help
THANKS!
Attachments
eeprom_settings.ini
(2.06 KiB) Downloaded 15 times

Return to “FAIL HAPPENS ! ! !”

Who is online

Users browsing this forum: No registered users and 1 guest