Fan not shutting off

A pre-assembled Delta Printer that can print a 6" cube 8" tall!
Jsmb768ypl
Plasticator
Posts: 7
Joined: Sun Feb 07, 2016 8:37 pm

Fan not shutting off

Postby Jsmb768ypl » Sun Feb 14, 2016 8:38 am

Okay so after a print finishes and the tower goes to home the fan still runs and makes this annoying whining noise how can i make it so the fan shuts off when the print is done?

User avatar
geneb
ULTIMATE 3D JEDDI
Posts: 4652
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Fan not shutting off

Postby geneb » Sun Feb 14, 2016 10:33 am

When the hot end drops below 60C, the fan will shut off automatically.

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects

Jsmb768ypl
Plasticator
Posts: 7
Joined: Sun Feb 07, 2016 8:37 pm

Re: Fan not shutting off

Postby Jsmb768ypl » Sun Feb 14, 2016 11:04 am

it didn't it was running all night after the print finished.

User avatar
geneb
ULTIMATE 3D JEDDI
Posts: 4652
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Fan not shutting off

Postby geneb » Sun Feb 14, 2016 11:15 am

Are you referring to the PEEK fan? It will shut off below 60C.

If you're talking about the RAMBo or power supply fans, those will run as long as the power switch is on.

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects


Return to “ORION”

Who is online

Users browsing this forum: No registered users and 1 guest