eeprom resetting

Talk about the Repetier Host software here (
Post Reply
Posts: 15
Joined: Tue May 13, 2014 12:02 pm

eeprom resetting

Post by mmorgan11 » Mon Sep 28, 2015 12:49 pm

Not sure if this is the best place to post this, but I have a max v2. I haven't used it for a while, but I got it up and running again and everything seems fine, but the eeprom keeps resetting. I usually print from SD card, and when I went to print today (after I unplugged my computer), The extruder didn't go down to the right z height, so I knew something was wrong. Then I plugged in and connected my computer and it said "printer reset detected - initializing". Any ideas why the printer is resetting? I don't think it happens every time I shut off the printer. Maybe it has something to do with not being plugged into the computer?


User avatar
Posts: 659
Joined: Sun Nov 03, 2013 12:27 pm
Location: Buenos Aires, Argentina

Re: eeprom resetting

Post by Tincho85 » Mon Sep 28, 2015 3:09 pm

Did you try clearing and uploading the firmware again?
Use 0.91, it's the last stable.
Martín S.

Post Reply

Return to “Repetier Host”