Surface Density of top layers

Talk about Cura software here (http://wiki.ultimaker.com/Cura)
RJLynn67
Prints-a-lot
Posts: 34
Joined: Mon May 19, 2014 12:34 pm

Surface Density of top layers

Postby RJLynn67 » Tue Feb 24, 2015 9:32 am

So I am just now printing my first part with Cura and I noticed something that looked odd in the preview but decided to go with it anyway. It seems from the preview that the top surface would not be as dense as I am used to seeing in the Slic3r preview.

GapsinTop.png


But due to time constraints I ran with it anyway. Now that I am in deep into printing the part I can see that tops layers are indeed solid but to me they do they do not looks as nice as the Slic3r. Now this could just be until I get the part off because it is just a different pattern.

Now I will say I am liking everything about Cura so far including the Print Time and Support structure.

Is there any differences in using Cura as stand alone vs in Repetier Host?

Return to “Cura”

Who is online

Users browsing this forum: No registered users and 1 guest