Page 1 of 1


Posted: Fri May 17, 2019 5:23 pm
by wes wortman
Just got a Artemis. I found something strange. At the end of a print is just sits at the last line of the print. With a hot nozzle and something pointed this is bad. Last print it just bonded the nozzle to my print. So why didn't it home. Frankly never had to mess with this on my other printers.

Cura 4.0 machine settings

End Gcode;

M203 Z24000
M104 S0
M140 S0

Re: Artemis

Posted: Sun May 19, 2019 9:29 am
by geneb
Take the M84 out. It turns the motors off. The weight of the effector will cause it to drop on to your print.


Re: Artemis

Posted: Wed May 22, 2019 1:38 pm
by wes wortman
Thanks I looked up each Gcode deleting 84 fixed it. Just saw your post.

Re: Artemis

Posted: Thu May 23, 2019 8:33 am
by geneb