Delta_geometry SpiderBot Effector_ Offset Test

All things related to the Rostock MAX 3D Printer, the worlds FIRST Delta kit!
Post Reply
hectori
Prints-a-lot
Posts: 26
Joined: Sun Feb 01, 2015 5:48 pm

Delta_geometry SpiderBot Effector_ Offset Test

Post by hectori » Mon May 07, 2018 7:21 pm

looking for stability in my effector I found this info.

http://reprap.org/wiki/Delta_geometry

I will show results. I hope to improve my first layer.
SpiderBot.png
DSC_0016.JPG
DSC_0017.JPG

hectori
Prints-a-lot
Posts: 26
Joined: Sun Feb 01, 2015 5:48 pm

Re: Delta_geometry SpiderBot Effector_ Offset Test

Post by hectori » Thu May 17, 2018 9:20 pm

My first Test.

I do the g33 with low speed to see if my platform tilts when the extruder touches the bed ( :D :lol: very happy the platform now stays completely straight.
with my previous system the platform was tilted a bit when it touched near the ends of the bed.

The Radius chnge from 137.35 to 158.50
and negative values between the towers disappeared.

I am Happy with the results. I will put some numbers.
https://www.youtube.com/watch?v=UgJDbpzhMHc

hectori
Prints-a-lot
Posts: 26
Joined: Sun Feb 01, 2015 5:48 pm

Re: Delta_geometry SpiderBot Effector_ Offset Test

Post by hectori » Tue Feb 19, 2019 12:33 pm


hectori
Prints-a-lot
Posts: 26
Joined: Sun Feb 01, 2015 5:48 pm

Re: Delta_geometry SpiderBot Effector_ Offset Test

Post by hectori » Thu May 02, 2019 1:40 pm

Hi
14ringsTest150microns.stl
(1.15 MiB) Downloaded 4 times
IMG14Rings.jpg
Calhex50.stl
(95.88 KiB) Downloaded 5 times
Hex50x50.jpg
MAX V2.jpg

Post Reply

Return to “Rostock MAX”