Use H1.1 for milling

All about the retired H-1.1 3D Printers
Post Reply
Paul Kelley
Plasticator
Posts: 13
Joined: Sat Aug 11, 2012 12:06 pm

Use H1.1 for milling

Post by Paul Kelley » Fri Sep 07, 2012 8:25 pm

I assume the H1.1 could be used for milling also. If so what other hardware and software could be used for this?

johnoly99
Printmaster!
Posts: 736
Joined: Mon Mar 26, 2012 1:07 pm
Location: Goshen, IN

Re: Use H1.1 for milling

Post by johnoly99 » Sat Sep 08, 2012 11:27 am

Well, you could get away with tiny cuts, go check out our youtube channel and see steve doing a monalisa portrait on acrylic

darus67
Prints-a-lot
Posts: 23
Joined: Mon Mar 26, 2012 7:59 pm
Location: Minneapolis, MN

Re: Use H1.1 for milling

Post by darus67 » Sun Sep 09, 2012 4:20 pm

How did that Mona Lisa turn out, anyway?
I was watching the stream live when it was running, but I don't recall seeing the finished run.

Post Reply

Return to “H-1.1 3D Printers”