Tool Caddy | 12v Power Center

Show off your latest creations, whether 3D printed or not
wepollock
Printmaster!
Posts: 180
Joined: Wed Apr 19, 2017 7:18 pm

Tool Caddy | 12v Power Center

Postby wepollock » Thu Jan 18, 2018 10:00 pm

Image

Image

User avatar
Jimustanguitar
ULTIMATE 3D JEDDI
Posts: 2631
Joined: Sun Mar 31, 2013 1:35 am
Location: Notre Dame area
Contact:

Re: Tool Caddy | 12v Power Center

Postby Jimustanguitar » Fri Jan 19, 2018 8:19 am

I've seen that switch panel before... Says something about zombies, right?

Nice looking prints!

User avatar
PartDaddy
Printmaster!
Posts: 344
Joined: Fri Mar 23, 2012 4:03 pm

Re: Tool Caddy | 12v Power Center

Postby PartDaddy » Sun Jan 21, 2018 8:11 am

Cool
~PartDaddy
SeeMeCNC Owner & Founder
Blackpoint Engineering is SeeMeCNC
Since 1996

User avatar
626Pilot
ULTIMATE 3D JEDDI
Posts: 1719
Joined: Tue May 14, 2013 12:52 pm

Re: Tool Caddy | 12v Power Center

Postby 626Pilot » Fri Jan 26, 2018 7:39 pm

I like the 12V box.

wepollock
Printmaster!
Posts: 180
Joined: Wed Apr 19, 2017 7:18 pm

Re: Tool Caddy | 12v Power Center

Postby wepollock » Thu Feb 01, 2018 4:34 pm

Jimustanguitar wrote:I've seen that switch panel before... Says something about zombies, right?

Nice looking prints!


Yep, zombie lights, that is for turning the dead on or off.. I was going to wire up a 12v distribution panel but it was much more efficient to purchase one intact.

https://www.ebay.com/itm/12V-6-Gang-LED ... 2749.l2649

My next step is to get rid of wall warts using buck converters or lm chips.


Return to “What are YOU making?”

Who is online

Users browsing this forum: No registered users and 3 guests