Having a problem? Post it here and someone will be along shortly to help
Post Reply
Posts: 1
Joined: Thu Nov 22, 2018 6:14 pm


Post by ken234 » Mon Nov 26, 2018 9:31 pm

I installed the seemecnc extruders on my Geeetech a10 and calibrated the e steps, it's working ok but the extruder will skip on the filament sometimes,I'm not sure if it's still feeding to fast or the extruder isn't hot enough and it jams.it prints ok and I haven't seen any problems in the print so far but just curious if anyone has any Idea what could be causing it

User avatar
Posts: 273
Joined: Wed Mar 12, 2014 2:34 am
Location: Lewisburg, Tennessee

Re: Extruder?

Post by rootboy » Sat Dec 08, 2018 10:52 pm

Okay, this is a head scratcher. Isn't the hotend on the Geeetech a direct drive extruder?

But the occasional skip isn't going to hurt anything. I usually get them (if I get them at all, that is) on the first layer.

Mac The Knife
Posts: 1370
Joined: Sun May 11, 2014 6:18 pm

Re: Extruder?

Post by Mac The Knife » Mon Dec 10, 2018 7:41 am

Did you check the current settings for the steppermotor in the firmware? I'm assuming you changed out the steppermotor also.
R-Max V2
Folger Tech FT-5 R2

Post Reply

Return to “Troubleshooting”