RMV2 + Cura Infill / Flow rate issues?

Having a problem? Post it here and someone will be along shortly to help
ExplodedZombie
Printmaster!
Posts: 80
Joined: Mon Nov 21, 2016 12:30 pm

RMV2 + Cura Infill / Flow rate issues?

Postby ExplodedZombie » Sun Oct 21, 2018 11:24 am

Hi everyone, I'm experiencing some weirdness. Had everything looking great and was about to print my first real model in a long time, then Cura crashed and lost all settings. Had to reset everything and now it seems to be printing far less material than before. Flow rate is 100%, Heat at 200c, I checked to make sure steps per mm was right, extruding 100mm. When I print a full cube the walls are a little thin and the infill is garbage. Looks like a thick spiderweb in there. Anyone seen this before?
Image

Return to “Troubleshooting”

Who is online

Users browsing this forum: No registered users and 7 guests