Quick Clip connector

Having a problem? Post it here and someone will be along shortly to help
Post Reply
User avatar
Glacian22
Printmaster!
Posts: 330
Joined: Thu Apr 04, 2013 6:07 am
Location: Seattle

Quick Clip connector

Post by Glacian22 » Thu Apr 26, 2018 7:47 pm

Hey all, I added a yellowjacket quickclip to my very modded RMax V1 a little while ago, in an effort to simplify my hotend wiring. If works well, but now the wire harness keeps coming loose, killing prints midway through. The wire harness feels like it clicks in securely, but I guess it isn't tight enough somehow? Considering adding a dab of hotglue, but that feels so counterproductive to have a quick disconnect. Any ideas?

User avatar
geneb
ULTIMATE 3D JEDDI
Posts: 4954
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Quick Clip connector

Post by geneb » Fri Apr 27, 2018 7:35 am

A bit of masking tape would work too. :)

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects

User avatar
Glacian22
Printmaster!
Posts: 330
Joined: Thu Apr 04, 2013 6:07 am
Location: Seattle

Re: Quick Clip connector

Post by Glacian22 » Fri Apr 27, 2018 6:47 pm

True! I think I'm just going to bite the bullet and go with a line of hot glue...it shouldn't be too hard to pry off later on.

Post Reply

Return to “Troubleshooting”