Eris auto calibrate issue

Having a problem? Post it here and someone will be along shortly to help
Posts: 1
Joined: Sun Jan 14, 2018 2:39 pm

Eris auto calibrate issue

Postby Laddyfam » Mon Jan 15, 2018 9:24 am

We have an Eris, and we are using Matter Control. When attempting to auto calibrate, the nozzle goes all the way onto the bed, starts vibrating, slides to the side and does not lift back up. :? We have tried a power cycle, and disconnecting and reconnecting the printer from Matter Control, to no avail. We have to shut the power off to the printer to get it to stop the vibrating on the bed surface. We would greatly appreciate any advice. :) Thanks for reading.

Mac The Knife
Posts: 1311
Joined: Sun May 11, 2014 6:18 pm

Re: Eris auto calibrate issue

Postby Mac The Knife » Mon Jan 15, 2018 12:14 pm

Mine did that also. I figured it had to do with an extreme difference in endstop offsets of the three towers. At the moment I forget what I did to get them closer to one another,,,,, But the endstops are the little plastic clips on the belt that activate a microswitch in the base. I was pretty frustrated and didn't update the thread I started in the Eris forum.
R-Max V2

Return to “Troubleshooting”

Who is online

Users browsing this forum: No registered users and 6 guests