User-Generated tips and tricks for the Rostock Max, Orion, H1.1, or H1 Printers
- Posts: 210
- Joined: Sun Feb 09, 2014 10:15 pm
- Location: Wakefield, MA
geneb wrote:The software does the moves
... but how does the software know when the nozzle hits the bed? Can it sense the load on the steppers?
- Posts: 150
- Joined: Tue May 14, 2013 11:42 am
the only problem is if you have an area lower than your set Z0 the software will not move below that.
- ULTIMATE 3D JEDDI
- Posts: 4837
- Joined: Mon Oct 15, 2012 12:47 pm
- Location: Graham, WA
The process that MatterControl uses utilizes YOU as the sensor. It will jog the head and ask you about where it's at. Just go through the process, you'll see what I'm talking about. It doesn't make any firmware changes so there's no harm in experimenting with it.
joecnc2006: Repetier-Host (and likely MatterControl) will not normally allow a -Z, but trust me if you send a "G0 Z-0.05", the firmware will obey it. (much to the displeasure of your build plate and nozzle...)
- Posts: 1
- Joined: Mon Jan 18, 2016 12:18 pm
THIS WORKS !!!!! whoot thank you
- Posts: 276
- Joined: Tue Sep 10, 2013 2:49 am
- Location: Houston, TX
Cool ... but with the Artemis this is a thing of the PAST!
well ... no for my V1, V2 and V3s LOL thanks then