Page 1 of 1

Sanguino Build Instructions or Log?

Posted: Tue Apr 03, 2012 3:29 pm
by solodude
Anyone have a good guide for wiring the H1 with a Sanguino...? or a solid build log ? Even photos?

Thanks in advance...! :)

-SD

Re: Sanguino Build Instructions or Log?

Posted: Tue Apr 03, 2012 11:29 pm
by michaellatif
I think as long as you follow the build instructions for the board you have and use the wiring instructions for the H-1 you have enough information to get it put together.
If you are looking for what wire to what pin, there is quite a bit of information on the RepRap wiki for your board, for example Sanguinololu:
http://reprap.org/wiki/Sanguinololu

For wiring schematics:
http://reprap.org/wiki/Sanguinololu#Wiring_shematics

For H-1 electronics manual:
viewtopic.php?f=39&t=69

Then I have a thread in this forum for settings used with Repetier Host/Firmware.
viewtopic.php?f=31&t=33

Let me know if you are looking for something else.

Re: Sanguino Build Instructions or Log?

Posted: Sun Apr 08, 2012 3:45 am
by solodude
I think I have the boot loader on my board but I need to get the firmware loaded now... I am trying to figure all this out but everything is so vague.

Re: Sanguino Build Instructions or Log?

Posted: Sun Apr 08, 2012 9:35 am
by mhackney
Ah, welcome to the world of open source!

Re: Sanguino Build Instructions or Log?

Posted: Sun Apr 08, 2012 10:20 am
by michaellatif
solodude wrote:I think I have the boot loader on my board but I need to get the firmware loaded now... I am trying to figure all this out but everything is so vague.


What board are you using and what firmware?