firmware install??

User avatar
hsb727
Plasticator
Posts: 12
Joined: Fri Aug 10, 2012 9:42 pm
Location: Pana, Illinois

firmware install??

Postby hsb727 » Thu Aug 16, 2012 12:52 am

1st
Is there firmware already installed on the ramps1.4 kit?
I assumed ( dangerous I know ) not and yet I get errors when
compiling the Repetier FW.. looking for a better source for firmware if
I must load one.
tnx

johnoly99
Printmaster!
Posts: 739
Joined: Mon Mar 26, 2012 1:07 pm
Location: Goshen, IN
Contact:

Re: firmware install??

Postby johnoly99 » Thu Aug 16, 2012 11:32 am

hsb, John here. The guys at ultimachine pre-load sprinter on the RAMPS boards. If you are having trouble compiling repetier, what version of arduino are you using? I've found if I use 0023 i don't get any problems, but V1.0 does have some compiling issues with some of the firmwares out there.
SeeMeCNC Co-Founder & V.P.

Polygonhell
ULTIMATE 3D JEDDI
Posts: 2430
Joined: Mon Mar 26, 2012 1:44 pm
Location: Redmond WA

Re: firmware install??

Postby Polygonhell » Thu Aug 16, 2012 5:31 pm

Most firmware will not complile with 1.0 without additional libraries I believe these are sufficient

https://github.com/Traumflug/Generation ... %202.0.zip

Marlin/Sprinter and Repetier all compile with 0.23 without issue


Return to “RAMPS”

Who is online

Users browsing this forum: No registered users and 1 guest