I was looking around at the various means of controlling my 3D printer when I came across this: http://www.ebay.com/itm/1-set-x-5-axis- ... 3a78f33b46
Definitely a lot cheaper than a TB6560 controlled board, but I'm wondering if the power output power is enough.
Any thoughts?
Alternative Driver board?
Re: Alternative Driver board?
That's ONLY a logic interface board, it's incapable of driving any kind of motor directly. The separate drivers for each motor are not included and need to be purchased to have a working solution.
Re: Alternative Driver board?
Ah, ok that would make sense given the lower power consumption.
Re: Alternative Driver board?
Hi everybody,
I dig up this old post to say that I'd devellopped my own board.
this is a very simple board, based on PIC programmed in C.
its design, as the SW is available on my web site.
Google translator will surely helps non french readers.
I dig up this old post to say that I'd devellopped my own board.
this is a very simple board, based on PIC programmed in C.
its design, as the SW is available on my web site.
Google translator will surely helps non french readers.
Return to “Parallel Port based boards”
Who is online
Users browsing this forum: No registered users and 1 guest