I see that some of the software topic sections have had no use since 2013 perhaps those topics could be reset for OnShape?
http://3dprintingindustry.com/2015/12/1 ... hape-apps/
Fusion360 might also make more sense than then little used ones
2 posts • Page 1 of 1
I'm not sure why we need so many sub-forums anyway. I always just "search for new posts" or "active posts" or the like... The topics should be more general, not more specific.
*not actually a robot
Who is online
Users browsing this forum: No registered users and 2 guests