Hi from Aus/NZ

Introduce yourself to the community!
Post Reply
AussieBlake
Prints-a-lot
Posts: 31
Joined: Wed Jul 08, 2015 1:49 am

Hi from Aus/NZ

Post by AussieBlake » Sat Jul 11, 2015 12:39 am

My MaxV2 has arrived in New Zealand... unfortunately I work in Australia and wont get to unbox it for a few days! Wish me luck...

An Aussie... working in Australia, living in New Zealand.... go figure.

User avatar
crocky
Printmaster!
Posts: 270
Joined: Tue Aug 12, 2014 6:55 pm
Location: Werribee, Aust

Re: Hi from Aus/NZ

Post by crocky » Sat Jul 11, 2015 7:15 am

That's a change... Plenty of New Zealanders living over here :)

You will enjoy the Rostock when you get it built...
Bob
Rostock Max V2, Ball Cup Arms, New Carriages, HE280, Dampers, PSU Breathing, Simplify 3D, GeckoTek3D, Raspberry Pi3. Duet soon... Kossel Mini still under construction.
Delta's are the way!

User avatar
PartDaddy
Printmaster!
Posts: 350
Joined: Fri Mar 23, 2012 4:03 pm

Re: Hi from Aus/NZ

Post by PartDaddy » Sat Jul 11, 2015 7:26 am

Welcome and thank you for choosing SeeMeCNC! Australia and New Zealand are on my bucket list.
~PartDaddy
SeeMeCNC Owner & Founder
Blackpoint Engineering is SeeMeCNC
Since 1996

User avatar
crocky
Printmaster!
Posts: 270
Joined: Tue Aug 12, 2014 6:55 pm
Location: Werribee, Aust

Re: Hi from Aus/NZ

Post by crocky » Sun Jul 12, 2015 5:49 am

Be glad to see you :)
Bob
Rostock Max V2, Ball Cup Arms, New Carriages, HE280, Dampers, PSU Breathing, Simplify 3D, GeckoTek3D, Raspberry Pi3. Duet soon... Kossel Mini still under construction.
Delta's are the way!

AussieBlake
Prints-a-lot
Posts: 31
Joined: Wed Jul 08, 2015 1:49 am

Re: Hi from Aus/NZ

Post by AussieBlake » Sun Jul 12, 2015 5:45 pm

Thanks for the welcome guys!

Getting into the build now!

Post Reply

Return to “New Member introduction”