Hello from Santa Barbara, CA

Introduce yourself to the community!
marvinsanremo
Plasticator
Posts: 5
Joined: Wed Mar 22, 2017 1:57 am

Hello from Santa Barbara, CA

Postby marvinsanremo » Thu Apr 13, 2017 7:57 pm

I just wanted to say hello to the forum. I recently bought a lightly used Rostock Max V2. It was completely stock with almost no hours on it. I went to work right away on upgrading some important parts (although I did learn how to calibrate it while everything was stock). So far I have installed the new cheapskates, new ball joint arms, new belts, Ultibot FSR kit and new TrickLaser FSR plate, PEI, and a partial teardown to shore everything up. I will be adding OctiPi, a new PS, e3d, and some side panels very soon. See you around the forums.

Penged
Printmaster!
Posts: 87
Joined: Sun Nov 29, 2015 5:30 am
Location: Alsip, Il

Re: Hello from Santa Barbara, CA

Postby Penged » Fri Apr 14, 2017 5:44 am

Welcome aboard. You will find a wealth of knowledge in this forum. Please don not be afraid to ask questions and share your experiences.
V2 max with the HE280 hotend


Return to “New Member introduction”

Who is online

Users browsing this forum: No registered users and 1 guest