I'm new around these parts

Introduce yourself to the community!
Post Reply
Posts: 1
Joined: Fri Nov 18, 2016 10:50 am

I'm new around these parts

Post by 80AM » Sat Nov 19, 2016 12:53 pm

Hey all, name is Adam and I'm new to 3D printing. Only been at it for a week, but already popped my PLA spaghetti on the build plate cherry. I use an Orion and I can't figure out how I have survived this long without it. I included a picture of it, the first thing I did was pimp it out a bit.

User avatar
Posts: 7185
Joined: Sun Apr 01, 2012 5:26 pm

Re: I'm new around these parts

Post by Eaglezsoar » Sun Nov 20, 2016 1:15 pm

Looks very nice Adam and thank you for buying from SeeMeCNC.
Nice pimp job and please remain an active member and welcome!

Post Reply

Return to “New Member introduction”