Hey from VA

Introduce yourself to the community!
Post Reply
jrkortze
Noob
Posts: 1
Joined: Fri Oct 04, 2019 9:59 am

Hey from VA

Post by jrkortze » Mon Oct 28, 2019 3:24 pm

Just purchased an Artemis 300 RTP for work, I'm completely new to 3D printing but trying to learn fast.
I did a clean install of Cura per SeeMeCNC's directions, and have printed one Benchy that had a lot of stringing, so now I'm running through some retraction test prints I got from All3DP, trying to clean things up a bit.

I'm looking forward to getting this thing dialed in and start cranking stuff out!

I'm also on the FB page. Helpful group there, so far.

-Jim

User avatar
geneb
ULTIMATE 3D JEDDI
Posts: 4969
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Hey from VA

Post by geneb » Tue Oct 29, 2019 1:36 pm

Jim, the stringing could be that you're printing the filament too hot - what material are you using? Are you slicing with one of SeeMeCNC's Cura profiles?

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects

CreatorGirl13
Noob
Posts: 4
Joined: Tue Nov 05, 2019 4:38 pm

Re: Hey from VA

Post by CreatorGirl13 » Mon Nov 11, 2019 5:27 pm

Did you figure it out?

Post Reply

Return to “New Member introduction”