extruder steps per mm settings?

Talk about KISSlicer software here (http://kisslicer.com)
User avatar
cristin
Plasticator
Posts: 10
Joined: Mon Jun 08, 2015 1:27 pm

extruder steps per mm settings?

Postby cristin » Thu Jun 18, 2015 12:58 pm

Hi there,

I was looking through the KISSlicer docs last night, and while the docs showed a place in the extruder settings for mm/rev, it wasn't there in my settings (latest stable on the mac)

is the documentation only for v1.5 and above? as I'm having issues getting enough material out on the first layer, lots of thin lines that aren't quite merging.
modded rostock max v2
driving it via astroprint.

User avatar
Tincho85
Printmaster!
Posts: 659
Joined: Sun Nov 03, 2013 12:27 pm
Location: Buenos Aires, Argentina

Re: extruder steps per mm settings?

Postby Tincho85 » Thu Jun 18, 2015 1:23 pm

How I did it:


Or you can check Triffid Hunter's calibration guide:
http://reprap.org/wiki/Triffid_Hunter%27s_Calibration_Guide
Martín S.

User avatar
Tincho85
Printmaster!
Posts: 659
Joined: Sun Nov 03, 2013 12:27 pm
Location: Buenos Aires, Argentina

Re: extruder steps per mm settings?

Postby Tincho85 » Thu Jun 18, 2015 1:25 pm

Oh you don;t know where it is, not how to calibrate it... well my bad.
Hope it helps someone else :D
Martín S.

User avatar
cristin
Plasticator
Posts: 10
Joined: Mon Jun 08, 2015 1:27 pm

Re: extruder steps per mm settings?

Postby cristin » Thu Jun 18, 2015 7:27 pm

I'll try installing the latest beta tonight and see if that fixes it.
modded rostock max v2
driving it via astroprint.


Return to “KISSlicer”

Who is online

Users browsing this forum: No registered users and 2 guests