KISSlicer

Talk about KISSlicer software here (http://kisslicer.com)
Ziggey
Printmaster!
Posts: 41
Joined: Sun Mar 29, 2015 2:54 am

KISSlicer

Postby Ziggey » Wed Apr 29, 2015 10:18 am

I downloaded Kisslicer and have been trying to familiarize myself with it. I have wanted a few videos read the setup ect. I'm rocking the Rostock Max V2. I supported the Diamond 3 in one printer on kickstarter and I would like to have Kisslicer homed in and ready to print by the time it gets here( A FEW MONTHS!!! :) )) So on that note My Kisslicer didn't start on the bed of the machine. What settings did I mess up???

Thank you,
Ziggey

Earthbound
Printmaster!
Posts: 458
Joined: Sun Sep 07, 2014 2:39 am

Re: KISSlicer

Postby Earthbound » Wed Apr 29, 2015 4:29 pm

Ziggey wrote:I downloaded Kisslicer and have been trying to familiarize myself with it. I have wanted a few videos read the setup ect. I'm rocking the Rostock Max V2. I supported the Diamond 3 in one printer on kickstarter and I would like to have Kisslicer homed in and ready to print by the time it gets here( A FEW MONTHS!!! :) )) So on that note My Kisslicer didn't start on the bed of the machine. What settings did I mess up???

Thank you,
Ziggey



Suggest starting from mhackney's very good initial configuration files in the KISSlicer sub-forum.
"Trust no quote from the Internet." - Abraham Lincoln

User avatar
mhackney
ULTIMATE 3D JEDDI
Posts: 5411
Joined: Mon Mar 26, 2012 4:15 pm
Location: MA, USA
Contact:

Re: KISSlicer

Postby mhackney » Wed Apr 29, 2015 11:33 pm

Moved to the Kiss topic...

Your issue is vague. It sounds more like you have not set Z=0 correctly rather than a slicer issue.

Sublime Layers - my blog on Musings and Experiments in 3D Printing Technology and Art

Start Here:
A Strategy for Successful (and Great) Prints

Strategies for Resolving Print Artifacts

The Eclectic Angler


Return to “KISSlicer”

Who is online

Users browsing this forum: No registered users and 1 guest