Silicone hot end sock?

This is where you can discuss the Rostock MAX v4!
Post Reply
GeckoDeLimon
Noob
Posts: 1
Joined: Fri Mar 22, 2019 9:19 pm

Silicone hot end sock?

Post by GeckoDeLimon » Wed Jun 05, 2019 4:23 pm

I've been trying to print more with PETG, and while I've got the stringing under control on my prints themselves, my nozzle & heater block are slowly being covered in black schmoo from the little whisps of PETG. It's also proving harder to remove than PLA deposits.

Will an E3D sock fit? I'd hate to be wrong and use something that "sorta fit". I can only imagine the mess.

Post Reply

Return to “Rostock MAX v4”