Page 1 of 1

Zesty Nimble

Posted: Tue Sep 18, 2018 7:55 pm
by quadcells
Hello All,
Has anyone installed the Zesty Nimble in the RailcoreII 300ZL?
I made a lg Delta printer with E3D V6 and the Nimble and the results are very good.
I thought the light extruder weight and remote extruder stepped would be a good fit for the RailcoreII.

/quadcells

Re: Zesty Nimble

Posted: Tue Sep 18, 2018 11:20 pm
by RanchRifle
Give it a shot and let us know how you like it! Sounds like it could be awesome. Don't forget that if you haven't already purchased the parts, these awesome folks have roped Project R3D into offering a kit now!

Also, I imagine most folks working on these outfits are going to be heading over to the new forum at forum.railcore.org

Re: Zesty Nimble

Posted: Wed Sep 19, 2018 5:28 am
by quadcells
Hello,
Yea I will ask the guys over at Zesty Nimble for their advice on the mount for it.
I already ordered most of the parts and I did see that they have kits now.
Thanks for the railcore forum site.
/quadcells

Re: Zesty Nimble

Posted: Tue Sep 25, 2018 10:15 am
by quadcells
RanchRifle wrote:Also, I imagine most folks working on these outfits are going to be heading over to the new forum at forum.railcore.org

I registered over there but still not activated. Does it take a while?

Re: Zesty Nimble

Posted: Thu Sep 27, 2018 10:16 am
by RanchRifle
I doubt it is automated. May have to wake him up?

Re: Zesty Nimble

Posted: Fri Sep 28, 2018 3:12 pm
by quadcells
The activation email was in my spam folder.