Filament run out monitor

firebass08
Noob
Posts: 3
Joined: Tue Apr 17, 2018 9:28 am

Filament run out monitor

Postby firebass08 » Tue May 01, 2018 4:48 pm

I'm considering a filament check.
What would y'all recommend or use for a filament check?

The duet monitor or just a switch or other?

https://duet3d.dozuki.com/Wiki/Duet3dFi ... netVersion

https://www.thingiverse.com/thing:2577717

kraegar
Printmaster!
Posts: 158
Joined: Sat Mar 28, 2015 1:27 pm

Re: Filament run out monitor

Postby kraegar » Wed May 02, 2018 9:12 am

I'm waiting to test out the new duet monitor when it's available (or they send me one).

I've not ever actually used a filament monitor to be able to recommend anything specific, though.

User avatar
Xenocrates
ULTIMATE 3D JEDDI
Posts: 1545
Joined: Wed Sep 23, 2015 2:55 pm

Re: Filament run out monitor

Postby Xenocrates » Wed May 02, 2018 9:48 pm

It depends on your use case and failure modes. If slipping is a problem for you, a filament monitor can help a lot. Same with jamming.

A simple switch only detects breaks, and running out of filament. Now, for say, a college using cuts off of spools, a switch handles most failure modes I've seen (as the students mostly don't get to print with a full spool, nor for longer than a few hours, so anything lost isn't that bad, but being able to use the whole off-cut is much better for our budget).

For longer prints, or ones with more expensive filaments, a filament monitor is much better, because it will pause it if it jams (More likely with the filled filaments, too), or slips (if say, the drive gears are loading up).
Machines:
Rostock Max V2, Duet .8.5, PT100 enabled E3D V6 and volcano, Raymond style enclosure
Automation Technology 60W laser cutter/engraver
1m X-carve router

Sic Transit Gloria Mundi
01-10011-11111100001


Return to “RailCore”

Who is online

Users browsing this forum: No registered users and 1 guest