Artemis with Duet Filament Runout Sensor

The one, the only, the Atremis. Forum for the monster metal machine from SeeMeCNC
Post Reply
DeepsReddy
Noob
Posts: 2
Joined: Mon May 13, 2019 10:41 pm

Artemis with Duet Filament Runout Sensor

Post by DeepsReddy » Tue May 14, 2019 10:37 pm

Hey Guys,
New to the forum and the family. Purchased an Artemis this week because Deltas are cool and I wanted one.

Given the massive print volume, a filament runout sensor seems to make sense. Has anyone dabbled with adding a run-out sensor to their Artemis? Seems doable with the duet.

Looking for any wisdom or advice for those who have already tackled this issue.

Thanks,
D

alexzogh
Plasticator
Posts: 9
Joined: Sun Aug 25, 2013 2:07 pm

Re: Artemis with Duet Filament Runout Sensor

Post by alexzogh » Sun Jun 02, 2019 11:43 pm

You want to buy one of these : https://www.amazon.com/dp/B07JJ2835X/

Image

Instructions are here:
https://duet3d.dozuki.com/Wiki/Connecti ... NT7jwfg7Pw

To give you a hint, the M591 command goes into your config.g file and you want it to trigger a pause.g

Seemecnc should really make this anoption on their printers.

alexzogh
Plasticator
Posts: 9
Joined: Sun Aug 25, 2013 2:07 pm

Re: Artemis with Duet Filament Runout Sensor

Post by alexzogh » Mon Jun 03, 2019 12:00 am

Also see duet sells a “laser” filament detector too....

https://www.duet3d.com/DuetAddons/LaserFilamentMonitor

Instructions are here: https://duet3d.dozuki.com/Wiki/Duet3dFi ... serVersion

For £25, I might have to try it.

DeepsReddy
Noob
Posts: 2
Joined: Mon May 13, 2019 10:41 pm

Re: Artemis with Duet Filament Runout Sensor

Post by DeepsReddy » Mon Jun 03, 2019 10:08 pm

Awesome! Thanks for the reply.

Post Reply

Return to “Artemis”