Printing in mirror image

An affordable delta DIY kit made with high quality electronics/parts/hardware
madox
Noob
Posts: 4
Joined: Thu Oct 04, 2018 2:44 pm

Printing in mirror image

Postby madox » Mon Oct 08, 2018 2:53 pm

Image

When I printed the test tower above, the numbers came out mirror imaged. IS this due to a problem building the printer?
At one point, I was told to connect the XY, XY, and Z stepper motor wires to the X,Y, and Z sockets on the motherboard.
I took a guess at which XY was X and which was Y. If this was wrong, would that cause the mirror imaging?

Thanks!

dc42
Printmaster!
Posts: 417
Joined: Mon Mar 07, 2016 10:17 am

Re: Printing in mirror image

Postby dc42 » Tue Oct 09, 2018 2:37 am

Swap the X and Y motor connections, also swap the X and Y endstop switch connections assuming the printer homes correctly at present. If you are using software endstop position corrections then you will need to swap those X and Y values too.


Return to “Hacker Series - H2”

Who is online

Users browsing this forum: No registered users and 1 guest