v3 Calibration issue

The new for 2016 Rostock MAX v3!
Post Reply
Tychon
Noob
Posts: 2
Joined: Tue Mar 21, 2017 9:40 pm

v3 Calibration issue

Post by Tychon » Wed Mar 22, 2017 2:06 pm

New owner of a v3 here, looking to get some help with an issue I am having currently.

As of recent I am unable to calibrate my machine correctly. I keep getting an -OFFSET OFF BY TOO MUCH TRYING AGAIN- at the end of the calibration, resulting in it retrying and having this happen in a loop.

Things I've done
check belt tension
swap out accelerometer board
square my towers up
clearing eeprom/reflash firmware

But to no avail. Any help would be appreciated :)
cap.PNG

djarmag
Printmaster!
Posts: 102
Joined: Mon Jan 09, 2017 3:32 pm

Re: v3 Calibration issue

Post by djarmag » Wed Mar 22, 2017 2:41 pm

Maybe your endstop screws are too high or uneven, try screwing them all down so they are all the same level and try again. Are you using most current firmware? I think there was something buggy with the recent one so try the previous file.

Tychon
Noob
Posts: 2
Joined: Tue Mar 21, 2017 9:40 pm

Re: v3 Calibration issue

Post by Tychon » Wed Mar 22, 2017 2:53 pm

Welp now I feel stupid..

screwing int he carriage endstop screws fixed the problem instantly haha..


Many thanks for the help.

Post Reply

Return to “Rostock MAX v3”