Operation "stick to the damn glass ya bastard!" (AU)

Here's a place to share with others local to you
User avatar
McSlappy
Printmaster!
Posts: 809
Joined: Wed Dec 11, 2013 9:11 pm
Location: Queensland, Australia
Contact:

Re: Operation "stick to the damn glass ya bastard!" (AU)

Postby McSlappy » Sun May 17, 2015 6:30 pm

Maple syrup is a fickle beast. I've had prints that didn't hold at all, then I've had some that I was worried would never come off. That stuff is scary... Scary delicious!
I loved my Rostock so much I now sell them in Oz :)

User avatar
Macros
Plasticator
Posts: 8
Joined: Fri Apr 24, 2015 4:05 am
Location: Auckland, NZ
Contact:

Re: Operation "stick to the damn glass ya bastard!" (AU)

Postby Macros » Fri May 22, 2015 11:18 pm

I've had the most success with blue 2090 tape with a bit of Office Max glue stick on top. That and making sure I've got my first layer height is still in the ball park.
Malcolm
Makerbot Replicator 2, Rostock Max 2.0
Shapeoko 3 (Still waiting....)


Return to “Australia and New Zealand”

Who is online

Users browsing this forum: No registered users and 3 guests