Photos of the printer: https://imgur.com/a/wewc0
The printer is in great condition and works perfectly. It has under 20 days of printing time. The stock hotend was upgraded to an E3D V6. The build plate has a new 0.8mm PEI sheet, which will last a lifetime.
The extruder has been reconfigured in a flying configuration, which shortened the bowden tube dramatically without adding weight to the effector. Everything has been put together accurately and the arm joints have been tied down, resulting in zero backlash.
Prints come out flawless. Prints great at 80mm/s+ and high acceleration values.
Board is flashed with the latest SeeMeCNC Repetier firmware. I will include the z-probe that can be used for automatic calibration and bed leveling.
Shipping is available upon request.
Price reduction from $500 to $425.
Do you print/build/make/create 'stuff' for modifying SeeMeCNC machines? Post them here if you do so others can see and inquire about getting them!
2 posts • Page 1 of 1
Last edited by Fughazi on Fri Oct 27, 2017 5:00 pm, edited 1 time in total.
The price has been reduced to $425.
Who is online
Users browsing this forum: No registered users and 2 guests