Do you print/build/make/create 'stuff' for modifying SeeMeCNC machines? Post them here if you do so others can see and inquire about getting them!
1 post • Page 1 of 1
Here is our heavily upgraded Rostock Max V3. It has a new Duet Wifi control board, FSR calibration probes, E3D hot end, custom enclosure and many other upgrades. After getting it fully working, we are now moving and need to sell it! Check it out here: http://www.ebay.com/itm/-/142502541362?
Who is online
Users browsing this forum: No registered users and 3 guests