Search found 1157 matches

by KAS
Sun Dec 28, 2014 8:58 pm
Forum: Rostock MAX v2
Topic: Official Doc v2 Assembly Guide, Fig 4-4 and 4-5 wrong
Replies: 8
Views: 1597

Re: Official Doc v2 Assembly Guide, Fig 4-4 and 4-5 wrong

I agree, X Y Z laser cut markings on the top of all four large plates (like the main build plate) would make the build a lot smoother.
by KAS
Sun Dec 28, 2014 3:22 pm
Forum: New Member introduction
Topic: X-mas Rostock Max V2
Replies: 8
Views: 1470

Re: X-mas Rostock Max V2

Mac The Knife wrote:The little popping sounds are most likely air bubbles in the filament.



Gotcha. We'll I do hear a bit less but that very well could be my imagination or maybe because I'm a bit further into the spool of filament.


So much to learn...
by KAS
Sun Dec 28, 2014 2:40 pm
Forum: New Member introduction
Topic: X-mas Rostock Max V2
Replies: 8
Views: 1470

X-mas Rostock Max V2

So after leaving a million hints that I wanted a Rostock Max V2 for Christmas, I was surprised that my "beautiful wife" bought it! Now I wont lie and say it was a surprise, after all we have the same checking account.... After seeing the SeeMeCNC "purchase" i started sourcing the...
by KAS
Sun Dec 28, 2014 10:14 am
Forum: Troubleshooting
Topic: M119 shows X V Z
Replies: 2
Views: 699

Re: M119 shows X V Z

Awesome, thank you. Thought I was going nuts.
by KAS
Sun Dec 28, 2014 9:54 am
Forum: Troubleshooting
Topic: M119 shows X V Z
Replies: 2
Views: 699

M119 shows X V Z

I've installed everything following the assembly guide for a new Rostock Max V2. When I issue the M119 command in the Terminal in MatterControl I see the following. Is this something I messed up or is the labeling wrong for the Y axis? http://i482.photobucket.com/albums/rr189/Onuxis/XVZ.png
by KAS
Sun Dec 28, 2014 9:41 am
Forum: Rostock MAX v2
Topic: Official Doc v2 Assembly Guide, Fig 4-4 and 4-5 wrong
Replies: 8
Views: 1597

Re: Official Doc v2 Assembly Guide, Fig 4-4 and 4-5 wrong

Also, If you haven't already passed section 7, Take a look at image 7-11 "before" you start wedging the supports though the holes.

I failed to see any registration marks to determine top from bottom when I inserted the first time. When I got to 7-11, I realized I messed up.
by KAS
Sun Dec 28, 2014 9:28 am
Forum: Rostock MAX v2
Topic: Official Doc v2 Assembly Guide, Fig 4-4 and 4-5 wrong
Replies: 8
Views: 1597

Re: Official Doc v2 Assembly Guide, Fig 4-4 and 4-5 wrong

After reading so much text about how to carefully put the bottom plate top face in the proper alignment, the pictures Fig 4-4 and Fig 4-5 don't match the text or Fig 4-21...? The clearest way to see it is when comparing the two wider spaces rectangle holes in 4-5 and 4-21 Sorry for brevity, I'm in ...

Go to advanced search