Search found 7 matches

by Vulchikova
Wed Jun 13, 2018 12:37 pm
Forum: Troubleshooting
Topic: Filament Feeding Problem
Replies: 5
Views: 633

Re: Filament Feeding Problem

Good info. Like I said, I have been printing for several days now. The only thing that changed is that I installed a new hot end. I will play with the temps and see if that helps at all. The PLA is exactly the same (same spool) that I just printed about 200 meters of.
by Vulchikova
Tue Jun 12, 2018 10:43 pm
Forum: Troubleshooting
Topic: Filament Feeding Problem
Replies: 5
Views: 633

Filament Feeding Problem

Gents, I have just used my R-Max quite a bit over the last few days and its worked flawlessly... until now. The machine is now suddenly having a problem feeding the filament. It makes a clicking sound at the EZR Struder. The prints turn out horrible for obvious reasons. I have taken apart my hotend ...
by Vulchikova
Wed Jun 06, 2018 4:37 pm
Forum: Troubleshooting
Topic: Filiment stuck at hotend
Replies: 6
Views: 499

Re: Filiment stuck at hotend

Geneb, Thanks for the response. My bed is down quite firmly. I will check wires underneath to ensure they are not in a position to cause any springyness. The printer is currently on my dining room table, which is glass and not really the most stable surface, so there may be some inherent shimmy. I w...
by Vulchikova
Wed Jun 06, 2018 11:51 am
Forum: Troubleshooting
Topic: Filiment stuck at hotend
Replies: 6
Views: 499

Re: Filiment stuck at hotend

Well it did it again. Using Cura and the SeeMeCNC Pla Default profile, I printed the mounting bracket for the Due Interface. Worked beautifully! Went to print the back case and things started going weird. It only actually printed two layers. Then I noticed that crumbs were being left on the print an...
by Vulchikova
Tue Jun 05, 2018 4:57 pm
Forum: Troubleshooting
Topic: Filiment stuck at hotend
Replies: 6
Views: 499

Re: Filiment stuck at hotend

Another topic, I sometimes get "Z prove value is not consistent" during the double taps. Because these messages are not consistent, meaning: sometimes I get a few messages, other times I get just one, I have been generally ignoring them. Is this something to be concerned about?
by Vulchikova
Tue Jun 05, 2018 2:49 pm
Forum: Troubleshooting
Topic: Filiment stuck at hotend
Replies: 6
Views: 499

Filiment stuck at hotend

Greetings everyone! My son and I finally finished the Rostock Max 3.2 build last night. After updating firmware, calibrating, and rechecking everything I can possibly recheck, the filiment was loaded and I printed the demo steam boat print. I was stoked that it worked so well! There was a little str...
by Vulchikova
Tue Jun 05, 2018 2:36 pm
Forum: New Member introduction
Topic: Very New, very green
Replies: 1
Views: 594

Very New, very green

Greetings all, I have never owned or printed with any 3D printer before, though oddly enough I was involved in the design of FormLabs 1. I work with robotics fairly frequently and have been wanting a printer for quite some time so I can make some custom parts. After several months of research, readi...

Go to advanced search