Search found 6 matches

by metatts
Sat Apr 21, 2018 10:48 pm
Forum: New Member introduction
Topic: New to 3D printing and need help
Replies: 10
Views: 1011

Re: New to 3D printing and need help

if anyone can help please send me a PM.
by metatts
Sat Apr 21, 2018 10:47 pm
Forum: New Member introduction
Topic: New to 3D printing and need help
Replies: 10
Views: 1011

Re: New to 3D printing and need help

do i just measure the arms from hole to hole and that's the diagonal rod length? how do i get the horizontal rod radius?
by metatts
Thu Apr 05, 2018 4:17 pm
Forum: New Member introduction
Topic: New to 3D printing and need help
Replies: 10
Views: 1011

Re: New to 3D printing and need help

I need someone to explain how the diagonal rod length, horizontal rod radius, and max printable radius work together. How do I calculate what those numbers should be and how to fine tune them.
by metatts
Thu Apr 05, 2018 3:30 pm
Forum: New Member introduction
Topic: New to 3D printing and need help
Replies: 10
Views: 1011

Re: New to 3D printing and need help

I measured the arms from the center of both holes and it is 270mm. the software print leveling that I am talking about in mattercontrol asks that I use paper under the nozzle and click buttons to until there is resistance on the paper (see screen shots). it doesn't say anything about needing a senso...
by metatts
Wed Apr 04, 2018 10:21 pm
Forum: New Member introduction
Topic: New to 3D printing and need help
Replies: 10
Views: 1011

Re: New to 3D printing and need help

I am trying to use the print leveling in MatterControl 1.6. It looks like the arms were changed and i changed the hot end. I can't get the print scaling correct and I don't know how to setup the diagonal rod length, horizontal rod radius, and max printable radius. I have mattercontrol setup for the ...
by metatts
Tue Apr 03, 2018 10:36 pm
Forum: New Member introduction
Topic: New to 3D printing and need help
Replies: 10
Views: 1011

New to 3D printing and need help

Hello from Washington State. I am new to 3D printing. I have a Rostock Max V2 that i bought used. I am looking for help with setting up my v2. I don't have a lot of information on when the printer was purchased. i know it was modified with different arms and an e3d v6 hot end. I have downloaded the ...

Go to advanced search