Search found 6 matches

by ytumer
Tue Mar 20, 2018 12:19 am
Forum: Rostock MAX v2
Topic: Poll: Print quality with Astrosyn dampers
Replies: 12
Views: 2474

Re: Poll: Print quality with Astrosyn dampers

Thanks for the insight guys. I put my dampers in when I was initially building my RMv2 as I had seen them recommended. I decided it would be easier to do it from the beginning rather than after the fact. If the difference in quality isn't that great I won't go to the trouble of removing them as I am...
by ytumer
Thu Mar 15, 2018 1:22 am
Forum: Rostock MAX v2
Topic: Poll: Print quality with Astrosyn dampers
Replies: 12
Views: 2474

Re: Poll: Print quality with Astrosyn dampers

I might have to remove mine too...let me know how your print quality goes jevs.
by ytumer
Thu Mar 15, 2018 1:14 am
Forum: Rostock MAX v2
Topic: Tricklaser arm issue with bed leveling
Replies: 13
Views: 2546

Re: Tricklaser arm issue with bed leveling

Thanks for the update mate. It was an interesting read. I am considering upgrading my arms to CF tubes but I'm scared that I am going to cause myself more headache than it is worth.
by ytumer
Thu Mar 30, 2017 8:47 pm
Forum: Rostock MAX v2
Topic: New Power Supply / Opening the Bottom
Replies: 27
Views: 4197

Re: New Power Supply / Opening the Bottom

That's a very elegant solution.

How do you run them in series to get 24V?

EDIT: Would 2 of these work? http://www.ebay.com.au/itm/HP-DPS-460BB ... SwtfhYnsfe
Says 36A max. 24x1.2 = 28.8A used by my heated bed alone if I convert to 24V with an SSR.
by ytumer
Sun Mar 19, 2017 10:44 pm
Forum: Rostock MAX v2
Topic: Garbled text on LCD screen
Replies: 7
Views: 986

Re: Garbled text on LCD screen

Thank you for all of your replies. Unfortunately I still haven't been able to address this issue. I don't know much about firmware but is it possible that while upgrading the firmware one of the settings pertaining to the LCD display may have changed over the years that is specific to a different di...
by ytumer
Tue Mar 14, 2017 11:29 pm
Forum: Rostock MAX v2
Topic: Garbled text on LCD screen
Replies: 7
Views: 986

Garbled text on LCD screen

Hi all, After updating my firmware from Repetier 0.91 to 0.92.2 the LCD screen text becomes garbled every now and again. The only way to get it to display correctly after this happens is to either repeatedly disconnect/connect Repetier Host until it decides to display correctly or turn the power off...

Go to advanced search