Search found 6 matches

by BacklashRC
Mon Feb 13, 2017 4:18 pm
Forum: Rostock MAX v3
Topic: Rostock Max v3 calibrating script.
Replies: 41
Views: 15865

Re: Rostock Max v3 calibrating script.

Is it still recommended to run the script after the autocalibration (SeeMeCNC's delta calibration wizard), or is the script now built into the wizard? My first layer is thick at the bottom left of the bed, and thin at the top right.
by BacklashRC
Fri Feb 10, 2017 7:55 am
Forum: Rostock MAX v3
Topic: Various Questions from a Newb
Replies: 4
Views: 1123

Re: Various Questions from a Newb

So I have made the endstop adjustments. X=0, Y=1, Z=3, but the unlevel bed remains unchanged.

I have also run the bed PID auto tune and the heating problem persists.
by BacklashRC
Mon Feb 06, 2017 11:22 pm
Forum: Troubleshooting
Topic: Bed temperature when Printing from SD
Replies: 10
Views: 878

Re: Bed temperature when Printing from SD

I had similar problems show up a few weeks after converting my V2 to the HE280 hot end. It could not maintain temperatures above 200 something when the bed was also on. I tried a different power supply (my own lab supply) I had and that fixed the problem. I talked to tech support and they said it s...
by BacklashRC
Sat Feb 04, 2017 11:53 pm
Forum: Rostock MAX v3
Topic: Various Questions from a Newb
Replies: 4
Views: 1123

Re: Various Questions from a Newb

Thanks, Djarmag. I will investigate the autocal improvement that you posted.

Eric, I found the history. Thank you!
by BacklashRC
Fri Feb 03, 2017 9:55 pm
Forum: Rostock MAX v3
Topic: Various Questions from a Newb
Replies: 4
Views: 1123

Various Questions from a Newb

In the Repetier folder in the Github repository, there is a rostockv3.hex file. What is it for? The repetier.ino file is what the Rambo is populated with, using Arduino IDE. Second, I notice that the firmware for the Rostock Max V3 was updated on Feb 1st, 2017, but see no notes on changes made. Is t...
by BacklashRC
Thu Feb 02, 2017 7:41 pm
Forum: Rostock MAX v3
Topic: Bed temp drop/DEF SOLVED!!
Replies: 6
Views: 1925

Re: Bed temp drop/DEF SOLVED!!

You put the tape between the thermistor and the glass? I would think that it would be better to get the temp from the glass than the bed ring, since it is the glass that the filament is sitting on?

Go to advanced search