Search found 6 matches

by srgntforest
Mon Sep 12, 2016 11:08 am
Forum: Simplify3D
Topic: Hot end not heating
Replies: 4
Views: 1630

Re: Hot end not heating

ive been setting the temps using the preheat function in the drop down menu. i used mattercontrol, the seemecnc version for the rest of the time, it would heat the hot end. i have 5 days of print time and have tested the temps at the nozzle using a temp gun, they are within the standard sigma(error ...
by srgntforest
Mon Sep 12, 2016 10:49 am
Forum: What are YOU making?
Topic: GoPro mount for GoPros with piggyback accessories
Replies: 0
Views: 497

GoPro mount for GoPros with piggyback accessories

hi all, i just put up a mount for GoPros with accessories on the back, such as extended batteries and screens and such. the mount allows you to also use a chest harness without the GoPro being angled. All questions welcomed.

http://www.thingiverse.com/thing:1766537
by srgntforest
Sun Sep 11, 2016 6:22 pm
Forum: Simplify3D
Topic: Hot end not heating
Replies: 4
Views: 1630

Hot end not heating

hi all, so far I've amassed 5 days of print time on my rostock max v2 rev. 3. In that time, I've used simplify 3d almost exclusively, but there is a problem. I have my hot end set to T0, but simplify 3d will no heat it. it heats the bed, and set points work for the bed, but it would appear the hot e...
by srgntforest
Fri Mar 18, 2016 5:53 pm
Forum: What are YOU making?
Topic: Concentric layer fan shroud
Replies: 5
Views: 1582

Concentric layer fan shroud

hey everyone, I've had this up on thingiverse for a bit, and figured its would be good for the community. The design improves on the original, and removes the need for extra layer fans. http://www.thingiverse.com/thing:1377757
by srgntforest
Sat Jan 23, 2016 12:58 pm
Forum: Troubleshooting
Topic: Cannot Print with Software other than Mattercontrol
Replies: 3
Views: 658

Re: Cannot Print with Software other than Mattercontrol

the temperature did set to 100 celsius, but the the towers only home'd, they did no move down to the build plate
by srgntforest
Sat Jan 23, 2016 11:00 am
Forum: Troubleshooting
Topic: Cannot Print with Software other than Mattercontrol
Replies: 3
Views: 658

Cannot Print with Software other than Mattercontrol

Hello everyone, I recently finished my Rostock Max V2 Rev. 3 and I'm having a terrible time getting prints to work. The problem would appear to either be in Configuration.h, or my slicing software. I have tried Cura, and Simplify3D, but when the print starts, the nozzle crashes in to the build plate...

Go to advanced search