Search found 7 matches

by menza
Sat Jan 26, 2013 7:44 pm
Forum: H-1.1 3D Printers
Topic: Working Repetier Host Firmware Config
Replies: 3
Views: 2286

Re: Working Repetier Host Firmware Config

I am using a RAMBO board. The problem I have is that the Z Axis more or less seizes up when I try to move it in either direction. I don't have this problem using Marlin, so I assume it is something in my configuration. I used the stock Repetier for Rambo files.
by menza
Sat Jan 26, 2013 5:07 pm
Forum: H-1.1 3D Printers
Topic: Working Repetier Host Firmware Config
Replies: 3
Views: 2286

Working Repetier Host Firmware Config

Can anyone post a working repetier firmware configuration.h and pins.h files?
by menza
Tue Jan 22, 2013 9:26 pm
Forum: H-1.1 3D Printers
Topic: Z Axis motor lockup
Replies: 4
Views: 2684

Re: Z Axis motor lockup

Can it be fixed by modifying the configuration.h file?
by menza
Tue Jan 22, 2013 9:14 pm
Forum: H-1.1 3D Printers
Topic: Z Axis motor lockup
Replies: 4
Views: 2684

Re: Z Axis motor lockup

Tried that, it did not work. Redownloaded the Marlin firmware to the board and it work fne. I thne tried the Repetier firmware again and still no luck. Also tried changing the Zaxis feedrate. FYI I used the Repetier for Rambo firmware.
by menza
Tue Jan 22, 2013 7:33 pm
Forum: H-1.1 3D Printers
Topic: Z Axis motor lockup
Replies: 4
Views: 2684

Z Axis motor lockup

I have built a h-1.1. In testing things out, the motor on the z-axis seizes up when I use the software(Repetier) to tell it to go either up or down. It also will not turn at all and appears to be locked up when the RAMBO is powered up. I though it was the motor or the mount, but when I plug the z ax...
by menza
Mon Jan 21, 2013 7:41 pm
Forum: H-1.1 3D Printers
Topic: Several more questions
Replies: 1
Views: 1662

Several more questions

Got evrything hooked up and talking to my Rambo. I have a few more questions: 1. Do I print directly on the printer bed (heated bed when I get it hooked up) or should I tape a piece of glass on the bed. 2. Where exactly should the extruder head be when at positon (0,0,0) in the center of the print b...
by menza
Tue Jan 15, 2013 9:42 pm
Forum: H-1.1 3D Printers
Topic: Finished build, now 2 questions
Replies: 3
Views: 2069

Finished build, now 2 questions

I have basically finished building my printer. I have three questions. 1. Is there any place I can find a picture of where to mount the endstop switches. 2. I have the RAMBO controller. Are there any instructions for hooking it up to the printer and to the power supply. 3. Are there any general inst...

Go to advanced search