Search found 4 matches

by Hank106
Fri Aug 29, 2014 10:47 pm
Forum: General Tips 'N Tricks
Topic: Extruder jamming? Consider greasing the spool support
Replies: 5
Views: 768

Re: Extruder jamming? Consider greasing the spool support

I accomplish something similar by wrapping the spool holder arm with electrical tape after I noticed a wear pattern developing.
by Hank106
Thu Aug 14, 2014 9:18 pm
Forum: ORION Official Docs
Topic: Orion Repair Manual
Replies: 6
Views: 3526

Orion Repair Manual

Is there a manual available for typical repairs the Orion requires? Even just an assembly manual would be helpful for disassembling to fix something.
by Hank106
Sun Aug 10, 2014 8:46 am
Forum: Troubleshooting
Topic: Calibration Issue
Replies: 3
Views: 663

Re: Calibration Issue

Thanks for the reply.

It turns out that one of the Y axis support arms had slipped off the pivot pin at the cheapskate. I corrected that but am still having difficulty getting the calibration correct. It seems the Z height changes a little after successive tower homing runs.
by Hank106
Thu Aug 07, 2014 7:52 pm
Forum: Troubleshooting
Topic: Calibration Issue
Replies: 3
Views: 663

Calibration Issue

I just received my Orion printer and the first 3 parts seemed to print reasonably well. Then the quality feel off quickly and it failed the last 3 attempts due to the hot head scraping the parts off the bed. I went through the calibration procedure 1) Set Z height in advanced settings. 2) Went throu...

Go to advanced search